Firepower FS-250 Manuel d'utilisateur télécharger pdf

FS-250 OPERATING INSTRUCTIONS

Alarm Operation

In case of alarm, the Alarm LED flashes, LCD displays alarm condition and the panel buzzer sounds

steady. Local audible and visual signals and remote alarm signals operate.

When an alarm occurs, proceed according to the established emergency plan. Assure that all personnel

are accounted for, and notify the Fire Department to advise of the alarm and/or verify that an automatic

signal has been received at the Fire Department.

Authorized Personnel Only

To acknowledge the alarm:

To acknowledge the alarm, press the Acknowledge button. The local buzzer will be silenced and

the Alarm LED will change from on-flashing to on-steady.

To silence the alarm:

To silence the notification appliances after evacuation, where permitted, press the Alarm Silenced

button. The silenceable notification appliances will be silenced. The Alarm Silenced LED will be

on-steady.

Note: Do not reset the panel until the alarm has been cleared.

Warning: Alarm silence inhibit (if set) prevents the alarm from being silenced for a

predetermined time.

To reset panel after alarm:

When the alarm condition is corrected, return the panel to normal standby operation by pressing

the System Reset switch.

Trouble Operation

Trouble is indicated by:

Trouble LED flashes

LCD will display trouble conditions

Panel buzzer sounds on-pulsing

To acknowledge the trouble buzzer:

Press the Acknowledge button. The Trouble LED turns on-steady and the buzzer turns off. When

the trouble condition has been cleared, you may need to reset the panel to restore to a normal

standby condition.

Warning: Leaving the panel in a trouble condition may cause a fire alarm condition not to

initiate a fire alarm sequence.

Normal Standby Condition

The green AC Power On LED will be lit and no other indicators on.

For service, contact: ___________________________________________

Telephone Number: _____________________________________________

Frame these instructions and mount them near the control panel for operator reference.

Page 1

20 FS-250 OPERATING INSTRUCTIONS Alarm Operation In case of alarm, the Alarm LED flashes, LCD displays alarm condition and the panel buzzer sounds s

Pas de commentaire

Firepower FS-250 Manuel d'utilisateur